haier ESD402 - Manual (Page 8)

Serial Number: Version:00.00 Edition: Nov.-23-2005
Built-In Dishwasher Model: ESD400/ESD401/ESD402
Page 7 / 48
5.2 Parts supplied
A. 2 drain hose clamps
1-large 1-small
Make sure all these parts are included. See parts list for
accessories available for your dishwasher.
B. 2 No.ST4.2 X 18 Philips-head screws
C. Drain hose
Cabinet opening
Do not run water drain lines or electrical wiring where they can interfere with or contact dishwasher motor or legs.
The location where the dishwasher will be installed must provide clearance between motor and flooring.
Do not install dishwasher over carpeted flooring.
Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not
covered by the warranty.
A side panel kit is available from your dealer for installing your dishwasher at end of cabinet.
Check location where dishwasher will be installed.
The location must provide:
- Easy access to water, electricity and drain.
- Convenient loading. Corner locations require a 2” (5.1cm) minimum clearance between the side of the dishwasher
door and wall or cabinet.
- Square opening for proper operation and appearance.
- Cabinet front perpendicular to floor.
- Level floor .If floor at front of opening is not level with floor at rear of opening, shims may be needed to level
dishwasher.
NOTE: Shims must be securely attached to floor to prevent their movement when dishwasher is being operated.
If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it
winterized by authorized service personnel.
Make sure pipes, wires and drain hose are within the shaded area.
HELPFUL TIP:
If the floor in the dishwasher opening in uneven (example: tile flooring only part way into opening) you will needed to take special
care in measuring dimensions and in leveling dishwasher.