Hitachi CMP4221 - Manual (Page 18)

18
ENGLISH
OPERATING INSTRUCTIONS (continued)
Size Switching (continued)
Size Switc hi ng
Display area selection diagram (RGB input)
When you want to Set the display size to Input signal Display screen Remarks
Play a 4:3 image faithfully in a 16:9
screen in the standard vertical size
and horizontally squeezed.
Full
(Squeeze)
An image with an aspect ratio of 16:9
shrunk horizontally to 4:3 to display in a
4:3 screen.
Play a 4:3 image in a 16:9 screen
faithfully.
Normal
(4:3 signal)
Blanking occurs on both sides.
Play a 21:9 Cinema size image in the
4:3 image expanded vertically on the
16:9 screen.
Cinema
(Cinema)
In some cases, some slight blanking may
remain at the top and bottom.
Play a 4:3 image faithfully in a 16:9
screen with the height and with of the
middle of the screen enlarged on
equal scales and with both sides
appearing somewhat enlarged.
Panoramic
(4:3 Signal)
An image with an aspect ratio of
Panoramic shrunk horizontally to 4:3 to
display in a 4:3 screen.
ATTENTION
Using a wide-screen monitor
x This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV program, the image
would appear different from the original. Take this into consideration when making screen mode choices.
x Use of this monitor in its enlarged display mode with the wide feature enabled in coffee shops, hotels and other establishments for commercial or pubic
viewing purposes could infringe on the copyright holder’s right protected by Copyright Law.
x When a normal 4:3 image is displayed over the entire screen in the Panoramic mode, parts of the periphery of the image may disappear and/or appear
distorted in some cases. Use the 4:3 mode to view images, which were created in 4:3 mode.
x This mode allows 4:3 content to be viewed without picture distortion.
Automatic Adjustment of Screen Position and the Clock
Adjustment of the screen to a position suitable for the PC signal and the clock adjustment can be performed automatically
by pressing the AUTO button of the remote control.
CAUTION
Perform this adjustment for RGB and for each signal.
* Depending on the signal, satisfactory adjustment may not be possible in some cases. In such case, adjust by referring
to the Image Menu item.
Input Signal Screen Display
The input signal status can be displayed on the screen by pressing the RECALL button of the remote control.
埛 The display will go out in approximately 2 seconds.
RGB Input mode
H: 48.4 kHz
V: 60.0 Hz Input vertical frequency of RGB
Input horizontal frequency of RGB