haier HBF205E - Manual (Page 18)

17
English
Instructions for Using Cleaning Kit
1. Mix one gallon of warm water and one ounce of
cleaner in a bucket. DO NOT USE SOAP.
2. Remove the cleaner cap assembly, fill the jar and
reassemble. Leave the remaining solution in the
bucket.
3. Turn off the air cock on the regulator and turn off
the valve on the CO
2
tank.
4. Disconnect the keg coupler from the keg and then
disconnect the beer line from the tap.
5. Remove the faucet from the draft tower with the wench provided and attach
the fitting from the end of the cleaning bottle in its place. Make sure there is
a washer in the back of the fitting.
6. Hold the cleaning jar upside down until the solution runs through to the
bucket. DO NOT SQUEEZE THE JAR. THIS WILL CAUSE THE SOLUTION
TO LEAK.
7. Fill the jar with clean cool water and repeat the process until clear water
flows into the bucket.
8. Rinse the keg couple in the bucket with the remaining solution and then in
the bucket with the clean water.
9. Remove the cleaning fitting from the tower and replace the faucet. Make
sure the washer is in the back of the faucet.
10. Reattach the beer hose to the keg coupler and attach the keg coupler to
the keg.
Repeat the process for the additional tap system.
PROPER CARE ANd ClEANINg OF THE bEER
dISPENSER