haier HBF205E - Manual (Page 12)

11
Note: If only one keg is to be dispensed you must still complete all the above
steps. Simply leave one keg coupler disconnected in the upright / locked
position. Please make sure that the black shut off valves are on the C02
regulator are in the off position.
When stacking 2 kegs be certain to securely install the included
keg joining bracket with the supplied hardware.
Make sure the hoses are not damaged by the kegs.
Important Safety Message for Draft Beer Dispensing
When CO
2
is used for draft beer dispensing, the system must be adequately
protected against excessive pressure build-up. This is accomplished by the
already installed two safety devices with adequate relief capacity in the system.
Safety devices are installed in the following places:
A. On or immediately downstream from the CO
2
regulator.
B. On the keg coupler.
El Apoyo del barril
El Barril de la cerveza
Levante Vertical
Retainer
Screw
Fixing Screws Wing Nut
CO
2
Retainer
English