haier HBF205E - Manual (Page 10)

Clear Hose
Small Barb
STEP 1
DO NOT TURN ON GAS YET
Connect the CO
2
regulator to tank by
screwing regulator nut onto threaded tank
valve. HAND TIGHTEN ONLY – it is not
necessary to use a wrench to tighten this
nut. At this point make sure that both the
shut off (black) valves are in the off (side-
ways) position.
STEP 2
Attach one red gas hose to each of the shut off valve
outlets on the bottom of the regulator and clamp tight
using two of the white squeeze clamps provided.
STEP 3
Attach the other end of each red gas hose to
the LARGER of the two hose barbs
on the keg coupler and secure with
the remaining two white squeeze
clamps.
STEP 4
Locate the two clear hoses from the draft arm
installed previously.
(These should be inside the refrigerator at this point). Attach one clear
beer hose to the SMALLER hose barb on each keg coupler being
certain to push the hose completely onto the barb. This connection
does not require a white squeeze clamp.
9
C0
2
Cylinder
Clamp
Red
Hose
Large Barb
Keg Coupler
English