HP 3C905-TX - Manual (Page 9)

Connecting to a Netware 4.1 server
Windows for Workgroups
Connecting to a Netware 4.1 server
Windows for Workgroups Requirements
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.
• Vectra VL8 Driver name: 3C90X.LAN Size: 33KB Date: 2/5/98
• Vectra VL7 Driver name: EL90XIDS.INF Size: 2KB Date: 2/23/96
• DOS and MS-Windows for Workgroups 3.11 media.
• Novell Netware server that supports Net BEUI, NWLink IPX/SPX, and
• NWLink NetBIOS transfer protocols.
• 32-bit Netware client for DOS and MS-Windows.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Auto Select (N-Way)
• Boot PROM Disabled
• Media Type Auto Select (N-Way)
Procedure
1 With the HP Vectra turned off, install the 3COM Fast Etherlink 3C905
Vectra VL8 Vectra VL7
I/O Base Address FCC0h (PCI) FC40h (PCI)
Interrupt 9 (PCI) 9 (PCI)
c905.bk : ch_3.fb4 Page 1 Thursday, October 22, 1998 9:51 AM