HP 3C905-TX - Manual (Page 23)

Connecting to a Windows NT Server 3.51
Windows NT Workstation 3.51
20 Click on the “OK” button in the “3Com DRMON SmartAgent PC Software”
dialog box.
21 Click on the “Close” button in the “3Com NIC Diagnostics v1.0” dialog box.
22 Choose the default protocol TCP/IP, and any additional network
protocols by clicking the check boxes in the “Windows NT Setup” dialog
box and click “Continue”. (If you do not have the required information,
contact your network administrator.)
23 Check the boxes to add other TCP/IP components, and click on the
“Continue” button.
24 Click “OK” for the review of network settings in the “Network Settings”
dialog box.
25 If applicable, approve the default settings in the “NWLink IPX/SPX
Protocol Configuration.”
26 Set your IP address information in the “TCP/IP Configuration” dialog
box, and click “OK.”
27 (If you do not have the required TCP/IP Settings, contact your network
administrator.)
28 At the “Domain/Workgroup Settings” dialog box, click on “OK” to accept
the default “Workgroup” as your workgroup name. (If you do not have the
required information, contact your network administrator.)
29 To complete the installation, remove the floppy disk , and click on
“Restart Computer” button in the “Windows NT Workstation Networking
Setup” dialog box.
c905.bk : ch_7.fb4 Page 3 Thursday, October 22, 1998 9:51 AM