HP 3C905-TX - Manual (Page 34)

Connecting to a Windows NT Server 4.0
Windows NT Workstation Ver. 3.51
Connecting to a Windows NT Server 4.0
Windows NT
Workstation Ver. 3.51 Requirements
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
• 3COM Etherlink 3C905 ethernet card and drivers disk ver. 2.1.
• Vectra VL8 Driver Name: DRMONNT.INF Size: 16KB Date: 1/23/98
• Vectra VL7 Driver Name: OMESETUP.INF Size: 41K Date: 3/14/97
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Auto Select (N-WAY)
• Boot PROM Disabled
• Media Type Auto Select (N-WAY)
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 adapter
card into a PCI slot.
Vectra VL8 Vectra VL7
I/O Base Address FCC0h (PCI) FC40h (PCI)
Interrupt Request
Level
9 (PCI) 9 (PCI)
c905.bk : ch_11.fb4 Page 1 Thursday, October 22, 1998 9:51 AM