Memory, Quickspecs – HP QUICKSPECS DL380 User Manual
Page 38
NOTE:
NOTE:
NOTE:
NOTE: Memory configurations listed do not apply to "Factory Integrated Models".
DDR3 memory population guidelines
DDR3 memory population guidelines
DDR3 memory population guidelines
DDR3 memory population guidelines
For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool:
Some DIMM installation guidelines are summarized below:
For servers with eighteen (18) memory slots:
There are three (3) channels per processor; six (6) channels per server
There are three (3) DIMM slots for each memory channel; eighteen (18) total slots
Memory channel 1 consists of the three (3) DIMMs that are closest to the processor
Memory channel 3 consists of the three (3) DIMMs that are furthest from the processor
DIMM slots that are white should be populated first
Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs)
Do not install DIMMs if the corresponding processor is not installed
If only one processor is installed in a 2CPU system, only half of the DIMM slots are available
To maximize performance, balance the total memory capacity between all installed processors
It is not required, but it is recommended to load the channels similarly if possible
You can only have up to eight (8) ranks installed per channel
You can only install two quad-rank DIMMs per channel
You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty
Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel
Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset
For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically
For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots
will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system
No mixing DIMM voltage; all DIMMs must be the same voltage
DIMM Type ->
Registered Dimms (RDIMMs)
Registered Dimms (RDIMMs)
Registered Dimms (RDIMMs)
Registered Dimms (RDIMMs)
Unbuffered with ECC
Unbuffered with ECC
Unbuffered with ECC
Unbuffered with ECC
DIMMs (UDIMMs)
DIMMs (UDIMMs)
DIMMs (UDIMMs)
DIMMs (UDIMMs)
DIMM Rank ->
Dual Rank (2R)
Dual Rank (2R)
Dual Rank (2R)
Dual Rank (2R)
Quad Rank (4R)
Quad Rank (4R)
Quad Rank (4R)
Quad Rank (4R)
Single
Single
Single
Single
Rank (1R)
Rank (1R)
Rank (1R)
Rank (1R)
Dual Rank
Dual Rank
Dual Rank
Dual Rank
(2R)
(2R)
(2R)
(2R)
DIMM Capacity ->
2GB
4GB
8GB
8GB
4GB
16GB
1GB
2GB
DIMM Native Speed (MHz) ->
1333
1333
1067
1333
1067
1067
1333
1333
SLOTS THAT CAN BE POPULATED
SLOTS THAT CAN BE POPULATED
SLOTS THAT CAN BE POPULATED
SLOTS THAT CAN BE POPULATED
18 slot servers
18
18
18
18
12
12
12
12
MAXIMUM CAPACITY (GB)
MAXIMUM CAPACITY (GB)
MAXIMUM CAPACITY (GB)
MAXIMUM CAPACITY (GB)
18 slot servers
36
72
144
144
48
192
12
24
POPULATED DIMM SPEED (MHz)
POPULATED DIMM SPEED (MHz)
POPULATED DIMM SPEED (MHz)
POPULATED DIMM SPEED (MHz)
1 DIMM Per Channel
1333
1333
1067
1333
1067
1067
1333
1333
2 DIMM Per Channel
1333
*
1333
*
1067
1333
*
800
800
1333
1333
3 DIMM Per Channel
800
800
800
800
*
n/a
n/a
n/a
* - supported with ROM update via ROM Based Setup Utility (RBSU). UDIMM support is only on 12-slot servers
NOTES:
NOTES:
NOTES:
NOTES:
QuickSpecs
HP ProLiant DL380 Generation 6 (G6)
HP ProLiant DL380 Generation 6 (G6)
HP ProLiant DL380 Generation 6 (G6)
HP ProLiant DL380 Generation 6 (G6)
Memory
DA - 13234 North America — Version 25 — December 18, 2009
Page 38