Hitachi VT-M290A - Manual (Page 48)

MONITOR RECORDING
48
length will be shown on the display.
1
Turn on the VCR.
2
Set the VCR to the channel to be recorded.
3
Press IRT button.
Recording starts immediately when the IRT button is pressed, whether if you are
watching the same or a different channel. The recording length will be determined by
the number of times you press IRT button.
IRT Length Diagram
Each time you press IRT button, you will extend the recording time by 30 minutes at a
time up to 8 hours (or to the end of the tape).
When IRT button is pressed 18 times, the VCR will switch to the Stop mode
immediately and the VCR power will be turned off.
To stop the IRT operation, press STOP button.
The recording length time remaining is indicated on the display as the recording is
started.
Recording stops when 0:00 is reached.
Please note that in the SLP mode maximum recording time, assuming the tape is
started at the beginning, is 8 hours using T-160 (or 6 hours using T-120).
The TV that is connected to your VCR may be turned on or off during IRT recording.
MONITOR RECORDING
1