Install and configure the disk array, Setting the host mode for the disk array ports, Install and configure the disk array 21 – HP XP12000 User Manual
Page 19: Setting the host mode for the disk array ports 21
Installation
21
Install and configure the disk array
The HP service representative performs these tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing the channel adapters (CHAs) and cabling
• Installing and formatting devices
After these tasks are finished, you will use Remote Web Console,
Command View, Command View XP Advanced Edition, or LUN
Configuration and Security Manager to complete the remaining tasks listed
below. If you do not have these programs, your HP service representative
can perform these tasks for you.
Setting the host mode for the disk array ports
The disk array ports have host modes that must be set depending on the
host you use. After the disk array is installed use LUN Manager in Remote
Web Console XP (shown), Command View XP, or Command View XP
Advanced Edition to set the host mode for each port. The host mode setting
for HP-UX is 08.