HP 3C339 User Manual
Page 9
2 Connecting to a Netware 4.11 Server
Windows 95 SR2
Windows 95 SR2
Requirements
•
HP Vectra VE7/VE8 with Windows 95 SR2 installed.
•
3COM 3C 339 Token Ringcard and drivers disk
•
Windows 95 SR2 media.
•
Novell Netrware 4.11 server that supports Net BEUI, NWLink IPX/SPX,
and
NWLink NetBIOS transfer protocols.
Device Configuration
•
I/O Base Address
DC00
•
Interrupt Request Level
10
•
Boot PROM
Disabled
•
Transceiver Type
Auto Select
•
Network Driver Optimization
Windows or OS/2 Client
•
Plug and Play Compatibility
Disabled
•
Full Duplex
Disabled
Procedure
1
With the HP VE7/VE8 turned off install the 3COM 3C339 adapter card into
an PCI slot.
2
Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3
Insert the 3COM drivers diskette (downloaded from 3COM’s website) and
execute 3C3X9CFG.EXE.
4
Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5
If changes are required, save those changes and exit.
6
Remove the 3COM cards driver diskette and restart the machine.
7
After Windows loads, click on “Start,” to “Settings” and over to “Control
Panel.”
8
Double click on “Network” and select “Add.”
9
Choose to add an adapter, click on “Add” then on “Have Disk.”