HP 3C339 - Manual (Page 19)

4. Connecting to a Windows NT Server 4.0
Windows for Workgroups Ver. 3.11
4. Connecting to a Windows NT Server 4.0
Windows for
Workgroups
Ver. 3.11
Requirements
• HP Vectra VE7/VE8 with DOS and MS-Windows for Workgroups 3.11 in-
stalled.
• 3COM Token Ring 3C339 card and drivers disk ver. 5.0.
DOS ODI - File Name: Tl3c3x9.dos Size: 52KB Date: 2/28/97
• DOS and MS-Windows for Workgroups 3.11 media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI,
NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• I/O Base Address DC00
• Interrupt Request Level 10
Procedure
1 With the HP Vectra VE7/VE8 set to PNP enabled, turn the machine off
install the 3COM 3C339 TR adapter card into a PCI slot.
2 Power on the machine and allow it to boot to a DOS prompt.
3 Insert the 3COM drivers diskette (ver. 5.0) and execute 3C3x9CFG.EXE.
4 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5 If changes are required, save those changes and exit.
6 Remove the 3COM cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
7 Execute INSTALL.EXE.
8 Specify the settings as listed below:
❒ C:\NWCLIENT
❒ Yes
❒ Yes