1 connecting to a netware 3.12 server – HP 3C339 User Manual
Page 3
1 Connecting to a Netware 3.12 Server
Windows for Workgroups
1 Connecting to a Netware 3.12 Server
Windows for
Workgroups
Requirements
•
HP Vectra VE7/VE8 with DOS and MS-Windows for Workgroups 3.11 in-
stalled.
•
3COM 3C339TokenRing card and drivers disk
DOS ODI - File Name: tlvmp339.dos
DOS and MS-Windows for Workgroups 3.11 media.
•
Novell Netware server 3.12 that supports Net BEUI, NWLink IPX/SPX,
and NWLink NetBIOS transfer protocols.
•
Netware client for DOS and MS-Windows.
Device Configuration
•
I/O Base Address
DC00
•
Interrupt Request Level
10
•
Boot PROM
Disabled
•
Transceiver Type
Auto Select
•
Network Driver Optimization
Windows or OS/2 Client
•
Maximum Modem Speed
9600 Bps
•
Full Duplex
Disabled
Procedure
1
With the HP Vectra VE7/VE8 set to PNP enabled, turn the machine off
install the 3COM 3C339 adapter card into an PCI slot.
2
Power on the machine and allow it to boot to a DOS prompt.
3
Insert the 3COM drivers diskette and execute 3C339CFG.EXE.
4
Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5
If changes are required, save those changes and exit.
6
Remove the 3COM cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.