Single-processor lockstep population order, Multi-processor lockstep population order, Installing a dimm – HP BL460C G6 User Manual
Page 33
Hardware options installation 33
•
DIMM configuration on channel 1 and channel 2 of a processor must be identical.
•
In multi-processor configurations, each processor must have a valid Lockstep Memory configuration.
•
In multi-processor configurations, each processor may have a different valid Lockstep Memory
configuration.
Single-processor Lockstep population order
For Lockstep memory mode configurations with a single processor, populate the DIMM slots in the following
order:
•
RDIMM
o
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
•
UDIMM
o
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support ("
" on page
Multi-processor Lockstep population order
For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
•
RDIMM
o
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
•
UDIMM
o
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support ("
" on page
Installing a DIMM
CAUTION:
To avoid damage to the hard drives, memory, and other system components, the air
baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server ("
" on page
2.
Remove the server blade (on page
3.