D. bin control, E. float switch, D. bin control e. float switch – Hoshizaki FD-1001MWH(-C) EN User Manual
Page 34: Fig. 1 fig. 2 fig. 3

34
D. Bin Control
An infrared sensor is used to control the level of ice in the dispenser unit/ice storage 
bin (S1 dip switch 7 in the "ON" position). The infrared sensor is the primary bin control 
device. 20VDC powers the infrared sensor from the control board K6 connector. A green 
power LED and a yellow ice detection LED are located on the infrared sensor. See 
Fig. 1. The paddle-actuated mechanical bin control is used as a backup bin control and 
safety device. See Fig. 2. For further details, see "IV.D. Bin Control Check."
The paddle-actuated mechanical bin control may be used as a stand-alone bin control 
when the unit is placed on a standard Hoshizaki ice storage bin (S1 dip switch 7 in 
the off position). 
WARNING! Do not place S1 dip switch 7 in the off position on
dispenser unit applications.
Proximity 
Switch
Actuator 
Paddle
Ice Chute
E. Float Switch
A dual float switch is used to determine that there is sufficient water in the reservoir 
during fill and refill. The control board monitors the upper float switch to de-energize 
the inlet water valve when the upper float switch closes during fill and refill. The control 
board monitors the lower float switch to energize the inlet water valve when the lower 
float switch opens during the freeze cycle (refill). See Fig. 3. The control board monitors 
the time between the lower float switch opening and the upper float switch closing 
(90-second low water safety). The control board also monitors the time between the 
upper float switch closing and the lower float switch opening (30-minute freeze timer). 
No adjustment is required. For a float switch check procedure, see "IV.E.1. Float Switch 
Check."
Red (R) 
(upper float switch)
Black (BK) 
(common)
Dark Blue (DBU) 
(lower float switch)
Upper Float Switch 
(blue)
Lower Float Switch 
(white)
Plastic Retainer Clip
Spring Retainer Clip
Fig. 1
Fig. 2
Fig. 3
Infrared Sensor
Infrared Sensor 
Housing
Infrared Sensor 
Connector (20V DC 
from K6 connector on 
control board)
Infrared Sensor LED
Infrared Sensor LED
Infrared Sensor 
Lens
