Harbor Freight Tools 93212 - Manual (Page 21)

Page 21 For technical questions, please call 1-800-444-3353. SKU 93212
chuck guard
(201)
Properly in place
safety
Mechanism
Figure 25
safety
Mechanism
Pin (251) properly extended
into the recess, allowing
the lathe to operate.
rotating
Plate
(252)
5. the chuck guard (201) has a safety
interlock and the Lathe will not
operate unless the guard is properly
in place. Install the guard if not already
done so. Check to ensure that the Guard
(201) is in its operating position over
the Chuck (2). The Pin (251) must be
correctly seated in the recess in the
Rotating Plate (252) for the Lathe to
work.
Plug in the Lathe.
6.
Forward-OFF-Reverse Switch (181)
Power Switch (178)
Speed Control Knob (180) Figure 26
7. Move the Power Switch (178) to the “On”
position (switch will turn Red) and place
the Forward-Off-Reverse Switch (181) in
the direction needed.
Move the Variable Speed Control Knob
8.
(180) to the needed operating speed to
start the Lathe.
to stop the Lathe
Turn the Speed Control Knob (180) to 0. 1.
Move the Forward-OFF-Reverse Switch 2.
to OFF.
Turn the Power Switch (178) OFF.
3.
Unplug the Lathe when not in use. 4.
reV 10b