Hoover Vacuum Cleaners - Manual (Page 6)

How to assemble
1. Connect hose
To connect hose, insert hose into
opening of cleaner lining up the
arrow on the hose with the dot
on the cleaner. Turn the hose
clockwise until the arrow lines up
with the bar on the cleaner and
latch locks into place.
When the hose is attached prop-
erly, the hose cord plug will reach
to the receptacle on the cleaner.
Insert the plug firmly and as deep
into the receptacle as possible.
To disconnect hose, first remove
hose cord plug from receptacle.
Then, depress latch away from
hose connection opening in
cleaner. While holding latch, turn
the hose counterclockwise until
the arrow lines up with dot on the
cleaner. Remove hose.
2. Attach power nozzle
Attach power nozzle at the end
of the straight wand by fitting the
button projection on the nozzle
connector into the opening at the
end of the wand. Be sure the
nozzle is locked in place.
To release, press down on the
center of the spring latch.
5