Hoover Vacuum Cleaners User Manual

Page 16

Position round projection on end

of agitator (opposite the belt) into

the opening in the wall of the
nozzle base.

The cover attaches at the front of
the nozzle. Place the notched
edge at the front of the cover into
the groove in the nozzle base.

Slide belt side of agitator into
place, pushing the agitator slight-
ly to left, pulling it forward and

then down.

Roll agitator to make sure belt is
positioned properly.

While maintaining front connec-
tion, rotate cover over nozzle
base and pull nozzle cord through
opening in cover.

Turn nozzle over and replace
screws.