Hitachi RTX 900 - Manual (Page 4)

Warnings
4 311772G
CAUTION
Water or material remaining in unit when temperatures are below freezing can damage
motor and/or delay pump startup.
To insure water and material are completely drained out of unit:
1. Remove material line from sprayer.
2. Tip sprayer up as shown.
Before adding material or starting unit in cold weather, run warm water through pump.
Before adding material to hopper, install burp guard. When only a small amount of material
remains in the hopper, the burp guard prevents material from shooting out when the unit is
turned off. This material could splash in the operator’s eyes or on skin, or into the air.
ti9016a
ti9010a