HP 1103 - Manual (Page 82)

Select To do this
Processor C4 State Enable/disable the processor C4 sleep state.
Boot Options Set the following boot options:
● f10 and f12 Delay (sec.)―Set the delay for the f10 and f12
functions of Setup Utility in intervals of 5 seconds each (0, 5, 10,
15, 20).
● HP QuickWeb―Enable/disable the HP QuickWeb menu in Setup
Utility.
● Internal Network Adapter boot―Enable/disable boot from Internal
Network Adapter.
● Boot Device Priority―Set the boot device priority for:
◦ Internal hard drive (select models only)
◦ USB floppy
◦ USB CD/DVD ROM drive
◦ USB flash drive
◦ USB Hard drive
◦ USB Card reader
◦ Network adapter
NOTE: Only the devices attached to the system appear in
the boot order menu.
Diagnostics menu
Select To do this
Hard Disk Self Test (select models only) Run a comprehensive self-test on the hard drive.
Memory Test Run a diagnostic test on the system memory.
74 Chapter 5 Setup Utility