Hard drive – HP 1103 User Manual
Page 48
Hard drive
Description
Spare part number
Hard drive:
320-GB, 7200-rpm
627731-001
250-GB, 7200-rpm
635225-001
160-GB, 7200-rpm
635760-001
Hard Drive Hardware Kit (includes hard drive bracket, screws, and Mylar cover)
633491-001
Hard Drive Cable Kit
628532-001
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Service access cover (see
Service access cover on page 38
Remove the hard drive:
1.
Lift the Mylar (1) that covers the hard drive connector on the system board.
2.
Disconnect the hard drive cable (2) from the system board.
3.
4.
Remove the 3 Phillips 2.0×4.0 screws (3) that secure the hard drive to the computer.
5.
Lift the Mylar (4) that covers the hard drive to allow removal of the drive.
40
Chapter 4 Removal and replacement procedures