HP 1103 - Manual (Page 64)

13. Release the top cover by lifting the front edge until it disengages from the base enclosure.
Reverse this procedure to install the top cover.
Display assembly
Description Spare part number
25.7-cm (10.1-in) display assembly (includes display panel cable, 2 WLAN transceivers and cables, 2 WWAN transceivers
and cables (select models only), and webcam/microphone module and cable):
● WSVGA, anti-glare, LED display assembly in black for use only on Compaq-branded models 634493-001
● WSVGA, anti-glare, LED display assembly in black for use only on HP-branded models 633496-001
● WSVGA, anti-glare, LED display assembly in red 633498-001
● WSVGA, anti-glare, LED display assembly in blue 633499-001
● WSVGA, anti-glare, LED display assembly in white 633497-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see Battery on page 35 ).
b. Service access cover (see Service access cover on page 38 ).
c. Keyboard (see Keyboard on page 50 ).
d. Top cover (see Top cover on page 53 ).
5. Disconnect the WWAN antenna cables from the WWAN module (see WWAN and GPS modules
(select models only) on page 43 ).
6. Disconnect the WLAN antenna cables from the WLAN module (see WLAN module on page 45 ).
56 Chapter 4 Removal and replacement procedures