HP PE4240N - Manual (Page 55)

Using the TV 51
NOTE: The Channel options are 1, 2, 3, or 4. A broadcast may contain other closed caption data on
channels 2–4; for most uses, set the channel to 1.
8 Highlight and select Display so it turns red. Adjust the setting so it reads either Shadow or Box, and
then press Setting front panel button (Enter on the remote control).
9 Exit the menu.
Setting up VGA
Use this procedure to select the VGA source signal type (Normal is 640 x 480, Wide is 852 x 480).
1 Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for
steps to open and use the menus using the front panel buttons (or the remote control buttons).
2 Select and display Configuration menu.
3 Highlight and select VGA Source so it turns red. Adjust the setting so it reads either WIDE or
NORMAL, and then press Setting front panel button (Enter on the remote control).
4 Exit the menu.
Selecting color system
Select the color system for the Video input as Automatic, NTSC, or PAL input using this procedure.
1 Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for
steps to open and use the menus using the front panel buttons (or the remote control buttons).
2 Select and display Configuration menu.
3 Highlight and select Color System so it turns red. Adjust the setting so it reads Auto, NTSC, or PAL,
and then press Setting front panel button (Enter on the remote control).