HP PE4240N - Manual (Page 12)

8 Introduction
Identifying the remote control buttons
Remote control
item Description
Indicator light The red light blinks once each time a button is pushed. If the
red light blinks two times when a button is pushed, the remote
control batteries are low and need replacement.
Setup Use the SETUP button when programming the remote control
for component control; see “Programming the remote control
for component control” on page 53.
PWR Press PWR once to turn on or off the selected home
entertainment component.
TV, CBL/SAT,
DVD/VCR, or
HP.PC Press one of these buttons once to select a home entertainment
component to control, and then point the remote control at the
component.
HP.PC selects the HP Media Center PC (connected to the VGA
or DVI connector) and enables the HP MCPC special buttons
on the remote. Refer to “Using the HP MCPC with the TV
remote control” on page 21 for more information.
To program the remote control to operate a cable or satellite
set-top-box or a DVD or VCR, see “Programming the remote
control for component control” on page 53.
Keypad Use the keypad (0 ~ 9, +100) to directly select channels.
Mute Press MUTE once to turn sound off or on.
VOL Use VOL+ (or VOL–) to raise (or lower) the sound volume.
CH. RTN Press CH. RTN (channel return) once to recall the last channel
or to page back one screen in the main menu.
HP.MC Press HP.MC to Start Media Center or as the Media Center
button when using the HP Media Center PC.
CH Use CH+ (or CH–) to select the next higher (or lower) channel.
Guide Use GUIDE to display the program guide for a TV set-top-box
or for HP MCPC.
Exit/Back Use EXIT to exit out of the selected component’s menu or guide.
Use Back for the HP MCPC.
ADJ Use ADJ+ (or ADJ–) to select or adjust an item.
Up or down
buttons Use the cursor keys to move the cursor in a program guide or
in menu screens.
Enter Press ENTER once after entering channel numbers on some TV
models. Use ENTER as the OK button for the HP MCPC.