HP PE4240N - Manual (Page 42)

38 Using the TV
5 To fine tune the channel, do one of the following:
•
Highlight and select CH Fine Tune so it turns red. Adjust the setting to fine tune the channel
frequency, and then press Setting front panel button (Enter on the remote control).
Or
•
Highlight and select Auto Fine Tune so it turns red. Adjust the setting to read On to automatically
fine tune the channel frequency, and then press Setting front panel button (Enter on the remote
control).
6 Exit the menu.
Mapping channels
Use this procedure to change what the TV displays when you select a channel. For example, use this
procedure to have the TV show “CH 56” when you’ve select channel 38 from your input signal.
1 Make sure TV is the input signal for the main picture. Refer to “Selecting the input source” on
page 26.
2 Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for
steps to open and use the menus using the front panel buttons (or the remote control buttons).
3 Select and display TV Setup menu.