Install the battery, Charge the battery, Turn on the camera – HP Photosmart R837 User Manual
Page 7
Install the battery
1.
Open the Battery/Memory Card door by sliding the
door latch as indicated on the Battery/Memory
Card door.
2.
Insert the battery in the larger slot, pushing the
battery in until the latch catches.
3.
Close the Battery/Memory Card door.
To remove the battery, press the battery latch as shown
until the battery springs free.
Note
Fully charge the battery before using it
the first time (see
). Turn off the camera before removing the battery.
Charge the battery
To charge the battery in the camera:
1.
Plug the small end of the USB cable into the
camera and the large end into the power adapter,
then plug the power adapter into an electrical
outlet, as shown.
The camera's blinking Battery Charging light
indicates that the battery is charging. The battery
is fully charged when the Battery Charging light
turns on solid (see
Recharging the Lithium Ion battery on page 49
for information
on charging times).
2.
When charging is complete, disconnect the camera from the power adapter.
Note
For other methods for recharging the battery, see
Turn on the camera
To turn on the camera, slide the lens cover open until it
clicks, uncovering the lens.
To turn off the camera, slide the lens cover closed until
it clicks, covering the lens.
Caution
When sliding the lens cover, keep
your fingers clear of the lens. Fingerprints on the
lens can impair the quality of the picture.
HP Photosmart R837 Digital Camera
7