haier D29FV6-A - Manual (Page 8)

MENU
Volume up/ down
Channel position up/down
TV/Video
(input selector
3
B/G
144MHz
NORMAL
POWER
Switch on/ off the TV set
In the following, the methods of using power switch and remote control to switch on/off
power supply for the TV set will be explained.
Switch on/ off the TV set
Infrared receiver
Power indicator Power switch
Switch on/ off the TV set
1.Connect the power supply wire. Then press the power
switch button, the power indicator will light, in several
seconds the picture will display on the screen.
2. If the TV is in the state of standby, press the POWER
button or the CH+/- buttons on the remote control.
Note:
1. Press the P+/- buttons which is on the TV set to get
out of the standby state when the remote control is not
in use.
2. Press the POWER button on the remote control
to the standby mode.
3. Press the power button on the TV set to
completely power off the TV.
4. To eliminate the magnetization completely, the
TV set degausses automatically. There is the
sound ofPENG, it is natural.
Automatic stand by function
When the SCREEN SAVER is ON, If no signal has
been received, and after five minutes, it will stand by
automatically. If the SLEEP has been used, the SLEEP
function is priority. When the
Automatic stand by function is no available.
When it is AV status, the TV set will enter the screen
saver, after 5 minutes turn to stand by automatically .
SCREEN SAVER is OFF,
the