beautypg.com

Water, Drain – haier DWL3025 User Manual

Page 9

background image

8

WATER

You must have:
- A hot water line with 20-120 psi (138-862 kPa) water pressure.
- 120°F (49°C) water at dishwasher.
-

3

/

8

” (0.9 cm) O.D. tubing with compression fitting or flexible stainless steel braided fill line

(½”/1.3 cm) minimum plastic tubing is optional but not recommended).

- A 90° elbow with

3

/

8

” (0.9 cm) N.P.T. external pipe threads on one end.

Do not solder within 6” (15.2 cm) from water inlet valve.

DRAIN

You must:
- Use the new drain hose supplied with your dishwasher. If this is not suitable, use a new

drain hose with a maximum length of 12 feet(3.7 m) that meets all current AHAM/IAPMO

test standards, is resistant to heat and detergent, and fits the drain connector on your

dishwasher.

- Have a high drain loop 30 inches (76.2 cm)

above the subfloor or floor.

- Connect drain hose to waste tee or disposer inlet

above drain trap in house plumbing and

20 inches

(50.8 cm)

minimum above the floor.

- Use an air gap if the drain hose is connected to house

plumbing lower than

20 inches (50.8 cm)

above

subfloor or floor.

- Use ½” (1.3 cm) minimum I.D. drain line fittings.