haier DWL3025 - Manual (Page 14)

13
11b. No waste disposer + air gap
1. Cut end of drain hose “I” if needed (do not cut ribbed
section).
2. Attach drain hose to air gap “J” with large springtype
clamp. If the drain hose was cut, use a 1½” to 2” (3.8 to
5 cm) screw-type clamp*.
3. Use a rubber hose connector* “L” with spring or
screwtype clamps* “M” to connect air gap to waste
tee “P”.
This connection “P” MUST be before drain trap “O” and
above the floor at 15 4 /
5
” (40 cm) to 39 2 /
5
” (100 cm),at least
20” (50.8 cm) above the floor where dishwasher will be
installed. Go to step 12.
11c. Waste disposer, no air gap
1. Remove the disposer knockout plug.
Do not cut end of drain hose.
2. Attach drain hose “I” to disposer inlet “N” with large
spring type clamp “K”.
This connecting “N” MUST be before drain trap “O” and
at least 20” (50.8 cm) above the floor where dishwasher
will be installed.
11d. No waste disposer + no air gap
1. Cut end of drain hose “I” (do not cut ribbed section).
2. Attach drain hose to waste tee “P” with 1½” to 2”
(3.8 to 5 cm) screw-type clamp* “M”.
“P”
* Parts available from local plumbing supply stores.
3. The drain hose must be looped up and securely fastened
to the underside of the counter before going to the drain. Hose
loop must be a minimum of 30” (76.8cm) above floor.
Go to step 12.
This connecting MUST be before drain trap “O” and
at least 20” (50.8 cm) above the floor where dishwasher
will be installed.
3. The drain hose must be looped up and securely fastened
to the underside of the counter before going to the drain. Hose
loop must be a minimum of 30” (76.8cm) above floor.
Go to step 12.
See note 3
(30” loop)
See note 3
(30” loop)