haier DWL3025 - Manual (Page 17)

16
5. Measure height of cabinet opening from underside
of countertop to floor where dishwasher will be
installed “K” (you need the lowest point). Check
chart for that height opening. Put wheels “L” in the
required position. Turn both front leveler legs to the
same height.
HELPFUL TIP:
Built-up floors.
Measure height of opening from underside of
countertop to built-up floor. If the height is at least
33¾” (84.5 cm), the dishwasher will fit into the opening
without modification to the countertop or flooring.
Put wheels “L” in position 1 and turn the front leveler
legs up all the way.
Add shims as needed in the area shown to bring
dishwasher up to proper height.
Note: Shims must be securely attached to floor to
prevent their movement when the dishwasher is
operated.
Min. Cutout
Height
Wheel Position
(See Illustration)
Number of Turns
on Front Leg
34” (86.4 cm) 1 10
34¼” (87 cm) 2 5
34½” (87.6 cm) 3 0
Front Leg
If the minimum cutout height is less than 34” (86.4 cm), the adjustable legs can be removed
for additional clearance. This will allow the dishwasher to fit into a 33
4 /
5
” (85.9 cm) high
cutout, but the dishwasher will be more difficult to move into position. If the wheels are
removed, protect the floor when moving the dishwasher.
33¾”
(85.7 cm)
min.
2”
(5.1 cm)
2¾”
(7 cm)
2¾”
(7 cm)
6”
(15.2 cm)
Countertop
Shim
Shim
Shim
Built-up Floor