haier DWL3025 - Manual (Page 23)

4. Reinstall terminal box cover “H” with wires inside terminal
box. Go to step 5. The cover must be outside the box on the
right side. Make sure no wires are pinched by cover.
Do not leave the box without the cover.
22
3. Tighten clamp connector or conduit connector screws “G”.
Check that power supply cord does not touch dishwasher
motor or lower part of dishwasher tub. Go to step 5.
HELPFUL TIP:
Compression Fittings:
1 Slide nut “I” onto copper tubing “J” about 1” (2.5 cm).
2.Slide ferrule "K" onto the tubing. Do not position
ferrule on the end of the tubing.
3. Put the tubing into the elbow “L” as far as it will go.
4. Slide the nut and ferrule forward and start the nut
onto the elbow threads “M”. Be careful when handling
and positioning the copper tubing. It bends and kinks easily.
1a. Power Supply Cord Method:
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Water Connection