haier DWL3025 - Manual (Page 12)

11
HELPFUL TIP:
Wiring the dishwasher will be easier if you route wire into the cabinet opening from
the left side.
HELPFUL TIP:
Routing the water line through the left side of cabinet opening will make water
connection easier.
3. Direct wire method:
Cut a ¾” (1.9 cm) hole “C” in righthand cabinet side, rear
or floor. Optional locations are shown.
Wood Cabinet: Sand hole until smooth.
4. Run wire into house wiring junction box. Use strain relief method provided with junction
box. If no strain relief is provided, install a cUL-listed/CSA-certified clamp connector for
flexible-type wire. If installing conduit, attach a cUL-listed/CSA-certified conduit
connector to junction box.
5. Run other end of wire through cabinet hole. Cable must
extend to the left front of cabinet opening. Go to step 6.
3a. Power supply cord method:
Cut a 1½” (3.8 cm) hole “D” in right-hand cabinet rear or
side. Optional locations are shown.
Wood cabinet: Sand hole until smooth.
4a. Install a mating, three-proung, grounding-type wall
receptacle “E” in the cabinet next to the dishwasher
opening. Go to step 6.
Water Line
6. Cut a ½” (1.3 cm) minimum hole “F” in left-hand cabinet
side,rear or floor. Optional locations are shown. (The hole
“F” is about 1
3 /
5
” higher than hole “C” or hole “D”)
6” (15.2 cm)