Honeywell NXL User Manual

Page 62

62(96)

Control Keypad

Honeywell

7.4.3 Keypad control menu (K3)

In the Keypad Controls Menu, you can choose the control place, edit the frequency reference and
change the direction of the motor. Enter the submenu level with the Menu button right.

Parameters in Menu

Selections

P3.1 = Selection of control

place

1 = I/O terminals
2 = Keypad
3 = Fieldbus

R3.2 = Keypad reference

P3.3 = Keypad direction

0 = Forward
1 = Reverse

P3.4 = Stop button activation

0 = Limited function of Stop

button

1 = Stop button always

enabled

P3.5 = PID reference 1

P3.6 = PID reference 2

7.4.3.1

Selection of control place

There are three different places (sources) which the frequency converter can be controlled from. For
each control place, a different symbol will appear on the alphanumeric display:

Control place

Symbol

I/O terminals

I/O term

Keypad (panel)

Keypad

Fieldbus

Bus/Comm

Change the control place by entering the edit mode with the Menu button right. The options can
then be browsed through with the Browser buttons. Select the desired control place with the Enter
button. See the diagram below. See also Chapter 7.4.3 above.

Figure 7-7. Selection of control place

enter

STOP

I/O term

READY

STOP

I/O term

READY

STOP

I/O term

READY

STOP

I/O term

READY

STOP

I/O term

READY