Quickspecs, Hp proliant dl160 generation 6 standard features – HP DL160 User Manual
Page 9
Power Supply
500 Watts, auto-switching, high efficiency, PFC (Power Factor Correcting)
NOTE: Factory upgradeable to high-efficiency (HE) pluggable or Hot Plug Redundant power supply.
System Fans
6 system fans ship standard; Non-hot plug, N+1 Redundant Standard
Operating Systems and
Virtualization Software
Support for ProLiant
Servers
NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and Virtualization
Software and latest listing of software drivers available for your server, please visit our Support Matrix at:
.
Rack Airflow Requirements
Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for maximum
cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure adequate
airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors, you must allow
5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to permit adequate
airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be a
minimum of 7 cm (2.75 inches)
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling that
can lead to thermal damage.
NOTE: For additional information, refer to the Setup and Installation Guide or the Documentation CD
provided with the server, or to the server documentation located in the Support section at the following
Rack Support
The DL Fixed Rail System supports installation in racks with square or round mounting holes (including
Compaq/HP 7000, 9000, 10000 and HP series), with an adjustment range of 24" - 36".
Telco Rack Support
Support for all 2 and threaded hole racks requires an additional option kit from Rack Solutions. The Rack
.
NOTE: The 4 post Telco racks also supported.
QuickSpecs
HP ProLiant DL160 Generation 6
Standard Features
DA - 13247 Worldwide QuickSpecs — Version 11 — 11.16.2009
Page 9