Hitachi ALPHA SERIES L32A404 - Manual (Page 12)

12
Quick Setup Guide
Perform the following steps to quickly setup your new
Hitachi LCD Television Set.
1. ANTENNA CONNECTION
Unless your LCD Television is connected to a cable TV system or
to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located
in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufficient.
a). VHF (75-Ohm) antenna/CATV (Cable TV)
When using a 75-Ohm coaxial cable system, connect the CATV coaxial
cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna,
connect the coaxial cable to the same AIR/CABLE terminal.
To outdoor Antenna
or
Cable TV (CATV)
System
To AIR/CABLE
Terminal
Rear Panel Jack
a). Connect the power cord to your TV set and secure it with the
wire Clamp (see page 7) .
b). Connect the power code to the AC outlet.
c). The Indicating Lamp will light red (Standby modes) and then
light blue (picture is shown).
Indicating
Lamp
2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE
3. POWER ON/OFF YOUR NEW HITACHI LCD TV
Press the POWER button on the remote control or the POWER
button on the Side Control Panel to power on/off the LCD TV.
NOTE
If the Indicating lamp is off, the POWER button
on the remote control will not operate. Please
make sure that the power cord is plugged to the
AC outlet.
or
RGB
RGB
AIR/CABLE
P.MODE S.MODE
1 2 3
4 5 6
7 8
0 9
MTS/SAP ASPECT
ENTER
LAST CH
MUTE
E.SAVE
MENU INPUT
INFO EXIT
CC SLEEP
SELECT
FAV.CH
VOL CH
CLU-4591AV
1
2
3
5
4
For Stand-By
Power OFF
4. FOLLOW THE SETUP WIZARD INSTRUCTIONS ON NEXT PAGE
Wire Clamp