HP VECTRA VA 6/XXX - Manual (Page 56)

3 Troubleshooting Your PC
Changing the Battery
48 English
After removing the computer’s cover and the air flow guide:
1 Remove the old battery by sliding it from under the retaining clip
(note the position of the cross).
2 Place the new battery in the battery holder, with the cross in the
same position as the old battery, and ensure that it is properly
seated. Ensure that the clip is in place and holds the battery firmly.
You can also install an external battery (HP part number 1420-0513),
which you can order from your authorized reseller. Install the external
battery as follows:
1 After removing the computer’s cover, connect the external battery
cable to the battery connector on the system board.
2 Mount the external battery on the chasis near the fan, using the self-
adhesive strip supplied.
After installing either a replacement or an external battery, replace the
computer’s cover and run the Setup program to reconfigure the
computer.
cobra-m3.fb4 Page 48 Wednesday, May 15, 1996 3:31 PM