HP VECTRA VA 6/XXX - Manual (Page 10)

1 Setting Up and Using Your PC
Unpacking Your PC
2 English
Unpacking Your PC
1 When you receive your PC, unpack all the components.
WARNING If you have any doubt that you can lift the PC or display safely, do not
try to move it without help.
2 Place the PC on a sturdy desk near to easily accessible power outlets,
with enough space for the keyboard, mouse, and any other
accessories.
3 Position the PC so that its rear connectors are easily accessible. (You
can place the PC on the floor instead of on the table, if desired.)
4 Refer to the display’s manual for information about the display.
Operating System Your PC’s operating system is packed separately inside the box that
contains your PC.
Installation Tools No tools are required to set up your PC. However, if you plan to install a
disk drive or an accessory board in your PC, you will need a flat-blade
screwdriver. For further information about installing accessories, refer
to chapter 3, “How to Install Accessories In Your PC”.
Manuals
Mouse
Typical Display
Computer
Keyboard
Two HP CD-ROMs:
Drivers
Documentation
cobra-m1.fb4 Page 2 Wednesday, May 15, 1996 3:26 PM