HP VECTRA VA 6/XXX - Manual (Page 25)

English 17
2 How to Install Accessories In Your PC
Installing Memory
Upgrading the MGA Millennium Board Memory
1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables. Remove the
computer’s cover.
2 Unscrew and remove the screw securing the MGA Millennium board.
Put the screw to one side. Note which slot the board is in.
3 Carefully remove the board from its slot, holding the board at each
end by its top edge. Do not bend the board. With its components
facing up, place the board on a clean, flat, solid, static-free surface.
Handle the board by its edges.
4 Install the memory module on the video board. Carefully slide the
board back into its slot. Firmly press the board into the socket. Make
sure that the board’s connector engages completely with the socket
and does not touch components on other boards you may have
installed. Secure the board by replacing the screw.
Carefully install the video
memory module
cobra-m2.fb4 Page 17 Wednesday, May 15, 1996 3:28 PM