HP 3C509B ISA - Manual (Page 29)

10 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter
Microsoft Windows NT 3.51 Workstation
10 Installing the 3COM EtherLink III 3C509B ISA 10BT
Network Adapter
Microsoft Windows NT
3.51 Workstation
Connecting to a
Windows NT 4.0 Server Requirements
• HP Vectra with Windows NT3.51 Workstation.
• 3COM EtherLink III 3C509B-TP ISA 10BT network adapter and driver
disk version 6.0.
• Driver File: ELNK3ND3.SYS, version 5.26.31
• Microsoft Windows NT 3.51 Workstation media.
• Microsoft Windows NT 3.51 Service Pack 5.
• Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport and NWLink NetBIOS network protocols.
Device Configuration
Procedure
1 With the HP Vectra turned off, install the 3COM 3C509B network adapter
into an ISA slot.
2 Connect network cable media to the 3COM 3C509B network adapter.
3 Power on the machine and boot to a DOS bootable disk.
4 Insert the 3COM 3C509 driver disk and execute “3C5X9CFG.EXE”.
5 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
6 If changes are required, save those changes and exit.
7 Remove the 3COM 3C509B driver disk and reboot the system to Windows
NT.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 10 05 05
I/O Address 300 300 300