HP 3C509B ISA - Manual (Page 27)

9 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter
Microsoft Windows NT 3.51 Workstation
9 Installing the 3COM EtherLink III 3C509B ISA 10BT
Network Adapter
Microsoft Windows NT
3.51 Workstation
Connecting to a
Windows NT 3.51 Server Requirements
• HP Vectra with Windows NT 3.51 Workstation.
• 3COM EtherLink III 3C509B-TP ISA 10BT network adapter and driver
disk version 6.0.
• Driver File: ELNK3ND3.SYS, version 5.26.31
• Microsoft Windows NT 3.51 Workstation media.
• Microsoft Windows NT 3.51 Service Pack 5.
• Microsoft Windows NT 3.51 Server system that supports NetBEUI,
NWLink IPX/SPX Compatible Transport and NWLink NetBIOS network
protocols.
Device Configuration
Procedure
1 With the HP Vectra turned off, install the 3COM 3C509B network adapter
into an ISA slot.
2 Connect network cable media to the 3COM 3C509B network adapter.
3 Power on the machine and boot to a DOS bootable disk.
4 Insert the 3COM 3C509B driver disk and execute “3C5X9CFG.EXE”.
5 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
6 If changes are required, save those changes and exit.
7 Remove the 3COM 3C509B driver disk and reboot the system to Windows
NT.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 10 05 05
I/O Address 300 300 300