HP 3C509B ISA User Manual
Page 12
4 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter
Microsoft Windows 95 SR2.5
4 Installing the 3COM EtherLink III 3C509B ISA 10BT
Network Adapter
Microsoft Windows 95
SR2.5
Connecting to a NetWare
4.11 Server
Requirements
•
HP Vectra with Windows 95 SR2.5.
•
3COM EtherLink III 3C509B-TP ISA 10BT network adapter and drivers
disk version 6.0.
•
Driver File: ELNK3ND3.SYS, version 5.26.31
•
Microsoft Windows 95 SR2.5 media.
•
Novell NetWare 4.11 Server that supports IPX network protocol.
•
Novell Client for Windows 95 v2.5 installation media.
Device Configuration
Procedure
1 Power on the system and start Windows 95SR2.5.
2 From the 3COM 3C509B driver disk, run PREINSTL.EXE.
3 Shutdown and power down the system. With the HP Vectra turned off,
install the 3COM 3C509B network adapter into an ISA slot.
4 Connect network cable media to the 3COM 3C509B network adapter.
5 Power on the system and press SHIFT-
command prompt.
6 Insert the 3COM 3C509B driver disk and execute “3C5X9CFG.EXE”.
7 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
8 If changes are required, save those changes and exit.
Device Configuration
Vectra Vli8
Vectra VEi7
Vectra VEi8
Interrupt
05
03
07
I/O Address
210
210
210