Hitachi VT-FX616A - Manual (Page 7)

7
controls may result in damage and will often require extensive work by a qualified technician to
restore the video product to its normal operation.
e. If the video product has been dropped or the cabinet has been damaged.
f. When the video product exhibits a distinct change in performance - this indicates a need for
service.
19 Replacement Parts -- When replacement parts are required, have the service technician
verify that the replacements he uses have the same safety characteristics as the original parts.
Use of replacements specified by the video product manufacturer can prevent fire, electric shock
or other hazards.
20 Safety Check -- Upon completion of any service or repairs to this video product, ask the
service technician to perform safety checks recommended by the manufacturer to determine that
the video product is in safe operating condition.
Getting Started
Relax. Using a VCR is very straightforward.
This sections explains how to hookup the VCR, quick tour of the controls, set up for first-time
operation using on-screen menus, and videocassette tapes.
Enjoy getting to know all about your Hitachi VCR. Let's get started.
n n n n Simple Hookups
1 Decide Where to Put Your VCR
n Be sure your chosen location allows for proper ventilation, stability, and protection from heat
and moisture (see Important Safeguards).
n Place the VCR near your TV but not on top of it. For convenience in using the remote control,
locate them no more than three feet apart.
n If you have an external cable or antenna, place the TV and VCR where you have ample cable
to hook them up. If necessary, you can purchase a cable extension and connector.
n If you plan to route your VCR audio through your stereo speakers for better sound
reproduction, place the VCR near the stereo receiver, or have enough long audio cables to make
the connections. (But keep in mind that the electronic signal weakens the further it has to travel.)
2 Decide Which Hookup Method to Use
To make your VCR function, you'll deal with two basic hookups:
1. The audio and video signal: If all you want to do is view a prerecorded videotape on the VCR,
this three-line hookup is the only one you need.
2. The radio frequency (RF) signal from a cable or antenna: Make this hookup if you also want
to record programs, or if you have no audio/video connectors on your TV.
We will show you the simplest hookups first and then present several variations to suit specific
needs. Be aware that you may need to purchase additional connectors to make the desired
hookup. These are available at video stores and electronic hardware stores.
Choose which hookup method to use based on:
n Your TV's capabilities
n The type of antenna or cable system you have (for cable box hookup, see Advanced