Hitachi DV-W1U - Manual (Page 13)

2 - 1
Parts to remove Item
Side cover (L), (R) 2-1
2-1 Top cover
2-3 JAK board
Parts to remove Item
2. Disassembly Method
When replacing defective parts, first refer to the "Parts hierarchy chart" shown below.
This chart shows the procedure for parts removal when replacing defective parts.
[How to use the parts hierarchy chart]
(1) Locate the part to be replaced.
(2) Check the parts in the ranks above the part to be replaced and start dismantling.
(3) Replace the defective part and reinstall the parts in the reverse order to that shown in the parts hierarchy chart.
1) Unplug the power cord from the AC outlet.
2) [Removal procedure]
If a special procedure is required when dismantling
any component, it is indicated using numbers.
Follow the numbers (1),(2),(3) ... shown in the
illustrations.
[Reinstallation procedure]
Reinstall each component in the reverse order to
removal when otherwise not specified.
3) Insert card connectors securely all the way as they
are of the direct insertion type.
Parts Hierarchy Chart
Note: Dismantle parts in the eject state.
1. Before Starting Disassembly
Fig. 1-1
2-2 Rear panel
2-3 IF board
2-5 DVD ROM
2-4 SW-CDR board
SW-DVD
(DVD SWITCH)
BOARD
CD-R
2-5 DEC board
2-6
REG (REGULATOR)
BOARD
CHAPTER 2 D I S A S S E M B L Y
2-3 REG board
2-4 SW-DVD board
2-4 FLHP board 2-3 Front cover
FLHP
(LCD DISPLAY)
BOARD
JAK
(REAR JACK)
BOARD
DEC (DECK)
BOARD
IF (INTERRFACE)
BOARD
SW-CDR
(CDR-SWITCH)
BOARD
Bottom cover 2-6