Horizontal surface mounting, Horizontal surface mounting -7 – HP 620 User Manual
Page 19
2-7
Installing and Connecting the ProCurve 620 Redundant and External Power Supply
Installation Procedures
In
stal
lin
g and
Co
nnec
tin
g th
e ProCurve
620 Re
dund
ant
a
nd Ex
ternal Power Supp
ly
2.
Hold the unit with attached brackets up to the rack and move it vertically
until rack holes line up with the bracket holes, then insert and tighten the
four number 12-24 screws holding the brackets to the rack.
Figure 2-2. Mounting the unit in a rack
Horizontal Surface Mounting
Place the unit on a table or other horizontal surface. The unit comes with
rubber feet in the accessory kit that can be used to help keep the unit from
sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the unit within the
embossed angled lines. Use a sturdy surface in an uncluttered area. You may
want to secure the EPS and RPS cables and the unit’s power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
C a u t i o n
Make sure the air flow is not restricted around the sides and back of the unit.