Husky POWERWASHER H2000 - Manual (Page 26)

PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Unit will not stop when trigger is
released (contd)
Wand is malfunctioning Test both wands to ensure that one is not
malfunctioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
Wand - Attaching To attach the Wand apply some moderate downward
pressure force on the Wand (In the direction of the
trigger) while simultaneously twisting the wand a 1/4
of a turn counterclockwise. (It may help if you set the
gun vertically on a flat surface with the wand pointing
upwards). The two tabs on the end of the Wand must
slide all the way in before the Wand will twist and
lock. If this does not work remove the o-ring from the
end of the wand and attach it without the o-ring. If the
wand attaches, you will need to replace the o-ring.
Contact us at:
[email protected]
or order a replacement directly online at:
www.huskypowerwasher.com.
Wand - Removing Release the back pressure in the Gun/Hose.
Remove the Garden Hose from the unit and
squeeze the trigger of the Gun. Apply some
moderate downward pressure force on the
Wand (In the direction of the trigger) while
simultaneously twisting the wand a 1/ of
a turn clockwise. (It may help if you set the
gun vertically on a flat surface with the Wand
pointing upwards). For additional assistance
you can email us at:
[email protected].
The green “Ready” light is not
illuminated.
NOTE: The green “Ready” light
should illuminate when the machine
is plugged in and the ON button is
depressed.
No power Check that the circuit is dedicated and rated
at 1 amps or greater.
The yellow “Medium” light will not
illuminate.
NOTE: The yellow “Medium” light
will only illuminate when using the
Click-N-CleanTM wand set to the
“Medium Fan Spray” or “Detergent
Spray” position and the gun trigger
is depressed, motor is running, and
water is spraying from the nozzle.
The Click-N-Clean TM is not set
to the proper position.
Make sure that the Click-N-Clean TM wand is set
to the “Medium Fan Spray” or “Detergent Spray”
position.
Use of improper extension
cord.
Use proper extension cord as recommended in
Owner’s Manual.
Clogged nozzle Clean nozzle as instructed in Owner’s Manual
section ..
The blue “High” light will not il-
luminate.
NOTE: The blue “High” light will
only illuminate when using the
Turbo lance, Flexi-lance, or Cli-
ck-N-CleanTM wand set to the
“High Pressure Fan Spray” posi-
tion and the gun trigger is depres-
sed, motor is running and water
is spraying from the nozzle.
Faucet not fully open or unit is
not receiving a full volume of
water.
Ensure that the faucet is fully open.
Check garden hose connection and ensure that
the garden hose meets criteria as described in the
Owner’s Manual.
Screen filter clogged. Clean the screen filter as instructed in Owner’s
Manual section ..