Hitachi 42PD7800 - Manual (Page 49)

49
ENGLISH
OTHER FUNCTIONS (continued)
DVD Player/STB Selection (continued)
Set up hint
Example) HITACHI DVD
ᕃ
To operate HITACHI DVD player, press and hold the button,
followed by the ᕃ button.
1. Press button to indicate the lamp of DVD on the remote
control.
During LED lighting, press
and ᕃ to set up the maker.
2. Release the ᕃ button once while keeping button, press
the ᕃ button again to set the maker type.
* After set up the maker type, press the button related with
DVD, and make sure that DVD player is working. In case
DVD player does not work, repeat 1 and 2 with other
numbers for the maker type to make sure it. (In this example,
press
ᕄ or ᕅ.)
NOTE
• Not all models of the listed makers can be operated using
this remote control.
Signal Check (RGB mode)
Changes in the signal status are displayed on the screen as they arise.
Status Display Action
When Mode Display is set to ON,
the input signal is switched or
when the RECALL button is
pressed. A guide is displayed for the input
terminal and the horizontal and
vertical sync frequency.
When the sync signal is no
longer detected. • A guide displays No Sync.
Signal, and Power Save (for
approx. 5 sec.)
• When the condition continues
where the sync signal cannot
be detected, indicator lamp of
power source changes in
orange and the mode switches
to power save mode.
Recheck the personal computer
power switch status and the
connection status.
When the input signal does not
match the monitor specifications
or is in an unstable status. A guide displays Invalid Scan
Freq. Recheck the input signal
specifications.
54 57 ~
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz
-- -- Min.
-- -- : -- --
OFF
! No Sync. Signal
! Invalid Scan Freq.
RGB