Hitachi 42PD7800 - Manual (Page 17)

17
ENGLISH
Mounting the Speaker Unit
INSTALLATION INSTRUCTIONS (continued)
Make sure that the main power swich of the monitor is turned off (standby or indicating lamp: off/red) when removing or connecting the
speaker cables.
CAUTION
Make sure to use the speaker systems fastened with the speaker
holders and the screws.
CAUTION
Mounting the Speaker System to the Monitor
1. Mounting the Speaker System to the Monitor
Hook the clamps (3 pieces) into the holes as shown in the figure,
and pull them down.
Follow the step in both Right and Left sides.
2. Attach the speaker holders
After twisting the screws off as shown, fasten the speaker system to the monitor with the speaker holder by the screws.
The speaker holder direction is opposite on the Right and Left speaker systems.
3. Attach the speaker connecting cables to the monitor. (Make sure the ferrite core is toward the monitor side)
Right Side
Rear of the monitor
Clamps
Right Side
Rear of the monitor
Twist off
the screws
Speaker holder
Monitor
Speaker
System
Speaker holder
Screws x 4
Screws x 4
Aluminum pieces
Screwdriver
NOTE
In case that the speaker
systems do not fit with
the monitor body’s
height.
When loosen the screws
fixing the aluminum pieces,
the speaker system is
movable up and down.
Adjust the position to the
monitor body’s height, then
tighten up the screws.
Pull off while twisting
Please prepare the supplieol
speaker cables
Treating the wire ends
Ferrite core Ferrite core
(R)
Red Black
(L)
Red Black
Connect the
copper
colored wire Connect the
silver
colored wire Connect the
silver
colored wire Connect the
copper
colored wire
Press down
the lever Raise
the lever Insert the wire
How to connect
the speaker
cables
(Moniter side)
Place to attach the side input.