Hitachi 42PD7800 - Manual (Page 14)

14
Connecting to an Audio Visual Device
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
Monitor (rear panel) Speaker (R) Speaker (L)
Power
cord
Side Input
T
o
component
output ter
minals
T
o
component
output ter
minals
T
o
S video
output ter
minal
T
o
composite
output ter
minals
T
o
audio
output ter
minals
T
o
audio output
ter
minals T
o
audio output
ter
minals
T
o
composite
output ter
minal
T
o
audio output
ter
minals
T
o
S
, composite
audio output ter
minal T
o
USB output
ter
minal
Headphone
T
o
composite
input ter
minals
T
o
audio input
ter
minals
Set-Top Box
Antenna
VTR VTR
VTR
DVD Player
DVD Player
T
o
component
input ter
minals
T
o
component
input ter
minals
TV Type only
Photo input terminal
(37/42 only)
• If a component input terminal and a composite input terminal of AV1 and AV2 connect to the monitor at the same time, component input would
govern.
• If a video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality.
(If an S video input terminal and a video input terminal of AV3 or AV5 (side input) connect to the monitor at the same time, S video input would
govern.)
• If the OUTPUT (Monitor) terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the
main unit. But it is possible to monitor only the composite video signal from AV1 ~ AV5 input or the S video signal from AV3 and AV5 that is
displayed on the screen at the time.
• The photo input function might not be provided, depending on a model.
• Secure connecting cables to the stand with the provided clamp.
HDMI*
• HDMI (High-Definition Multimedia Interface) is a digital interface based on DVI (Digital Visual Interface), which is an added function for audio
visual equipment.
– It does not have degradation by transmission since it is digital.
– With only one cable, it is possible to transmit both picture signals and audio signals.
• In case of using analog audio as connecting with DVI-HDMI transformation connector, use an analog audio terminal for AV1 input.
[An example of connecting audio visual devices]
INSTALLATION INSTRUCTIONS (continued)