Hitachi 42PD7800 - Manual (Page 13)

• In order to prevent an internal temperature increase, maintain a space of 10cm (4 inches
: For a desktop set-up) or more between the sides and other objects such as walls, etc.,
so that the ventilation holes are not blocked.(*)
CAUTION
13
ENGLISH
INSTALLATION INSTRUCTIONS
Installation
Use one of the special mount units to install this product. A mount of insufficient strength or inadequate design can cause overturning or
dropping and result in fire, electrical shock or injury. Please note that our company assumes absolutely no responsibility for personal injuries
or property damage caused by use of other mount units or improper installation.
WARNING
Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury.
CAUTION
Loosen a cord or chain enough while operating power swivel to avoid possible physical injury.
CAUTION
10cm or more*
Cord or chain
Clamp
Wall or Pillar
Anti-tumble measures
Securing to a wall or pillar
Using a commercially available cord, chain and clamp, secure the set to a firm wall or pillar.
Securing desktop
1) Using wood screws (two), fasten the set to the clamping screw holes on the rear of the
stand as shown.
2) Using commercially available wood screws, secure the set firmly in position.
Read SAFETY INSTRUCTIONS ( to ) carefully to ensure maximum safety before pro-
ceeding to these steps:
• Choose an appropriate site and install the product on a level table where the stand is secure.
• Install the monitor to have ready access to a power socket available.
• Make sure that the power switch of this device is turned off.
Hook
Cord or chain
Clamp
Cord or chain
Wall or Pillar
Two places
Wood screw
4 7